16 Zone Conventional Fire Alarm Control Panel

Specification

• 16 zones.Each zone can have maximum 32 conventional
  detectors. The total number of detectors and call points in a zone
  shall not exceed 32
• Each zone can be programed work as fire alarm (default) or
  supervisory alarm mode
• Each zone include 2 indicators, 1st indicator is bi-color( Red and
  Green), factory default to indicate fire condition. Red color on in case
  fire signal triggered; also can be programed to indicate supervisory
  condition. Green color on in case superisory signal triggered. 2nd
  abmer indicator flashes when the zone is in fault condition(0.5:0.5).
  And it illuminates steadily when the zone is disabled or in test mode.
• 1x Alarm output can be setup as 24V or N/O,N/C
• 3x sounder outputs, output 1 can be setup 24V or N/O N/C,
  output 2 and 3 only work as 24V output
• 1x Disable/supervisory relay ouput (N/O COM N/C)
• 1 x Fault output (N/O COM N/C)
• 1x Auxilary power output: output current 450mA in standby
  mode and Maximum 1000mA in alarm mode when the Alarm
  Output been set to a normally open/close contact type
• Able to report short circuit and open circuit of detection
  zones, sounder outputs and alarm output
• Designed with standby batteries and space provision for
  two sealed lead-acid batteries
• Easy operation to enable/disable zones, sounder outputs
  and alarm output
• Alarm Test function selectable with or without sounder
  notification
• Output programmable for interlink between zones and
  sounder outputs, alert or evacuate tone, with or without delay
• Different Silence/Reset/Test modes can be selected to
  meet local requirement
• Remote controls available for silence evac and reset
• Three access levels settable via key control
• Reserved repeater panel interface for fire alarm indication
  of multiple zones