Features
Common Features for all versions
Zones/outputs dynamic allocation Each zone and each output can be programmed as “Not used”. This will allow the installer to have the maximum number of zones even if an expander is not fully used. The panel will build a correspondence between the number of a zone and its physical location.
E.g. the zone nr. 7 can be located on expander nr. 1, terminal T1, and the zone nr. 8 can be located on ex- pander nr. 2, terminal T4.
On board Inputs
• 4 zones.
• 4 Programmable Terminals (Zones/Outputs).
• Zones supervision (NC / NO / EOL / DEOL).
• Fully-programmable input-zones.
• 1 supervised (10 Kohm EOL) 24h Tamper Zone.
On board outputs
• 1 Programmable Alarm Output 2 A relay (Bell output).
• 2 Programmable Open-Collector Outputs (100 mA each).
• 4 Programmable Terminals (Zones/100 mA Outputs).
• Fully Programmable Output options (polarity, Tim- ing, Events, Timers).
• Supervised Bell circuit.
Wireless
• 1 Wireless Receiver at 433 or 868 MHz.
• Up to 16 wireless Keys.
• Up to 32 wireless Detectors.
Interfaces
• New Bentel BPI Plus bus (+12 V only).
• KEYBUS bus for wireless receiver.
• PC-Link interface.
• USB On The Go Device/Host.
Options
• AS100 2-way audio station for remote listen-ing (speaker and microphone).
Communications
• Integrated PSTN interface.
• Phone Line monitoring.
• Double Call.
• Line-sharing Management.
• Up to 32 telephone numbers for Voice/SMS Dialler and Central Station.
• Supports CONTACT ID and SIA Reporting
• Programmable Test Call.
• Remote servicing.
• Periodic Transmission Test.
• Integrated Voice Calls.
• Up to 206 voice messages, total time 20,7 minutes.
• Voice Guide by Telephone, with Remote DTMF device management.
• Down-loadable Pre-Recorded Voice messages.
